384 lb works out to 3x45 + 1x35 per side plus the bar — call it 385 lb in practice, since gyms rarely stock the odd change. 2 reps sits at the reliable end of the range these formulas were fitted on, so the 32 lb spread here is about as tight as the method gets. Your 365 lb set represents about 95% of the estimated max.
Why 2 reps gives a tight estimate
A double is the shortest set these seven equations accept, and it is where they agree most closely. Every one of them was regressed on sets of two to ten reps, so two sits at the near edge of the fitted band rather than outside it, and the 32 lb between 375 and 407 lb is about as narrow as this method ever gets. The uncertainty at two reps is not in the arithmetic, it is in the set: a double you could have taken one rep further looks identical on paper to one that genuinely stopped you.
Training loads from a 384 lb max
Programmes are written as percentages of the max, not as absolute weights. From 384 lb, rounded to the nearest 5 lb:
| Percentage | Load | Typical set |
|---|---|---|
| 95% | 365 lb | Heavy single |
| 90% | 345 lb | Doubles and triples |
| 85% | 325 lb | Sets of four to five |
| 80% | 305 lb | Sets of six |
| 75% | 290 lb | Sets of eight |
| 70% | 270 lb | Volume work, ten or more |
384 lb is 3x45 + 1x35 per side plus the bar, 385 lb loaded. At this load the 32 lb the formulas disagree by is bigger than a pair of 10s, which is a good argument for programming off the lower estimate — 375 lb — and letting the bar prove you wrong rather than the other way round. Warm-up jumps also get long here; work up in percentages rather than in fixed plate increments.
The formulas behind this answer, and their limitations
The table above the fold is Epley (1985), Brzycki (1993), Lombardi (1989), O'Conner (1989), Wathan (1994), Lander (1985) and Mayhew (1992), each applied to 365 lb for 2 reps; the headline figure is their median. All seven assume a set taken close to failure with clean technique. At 2 reps you are inside the band they were fitted on, so the largest error here is not the equation but judging how close your set really was to failure — three reps left in the tank reads exactly the same to them. They also under-rate strong, experienced lifters, who hold a higher percentage of max at any rep count than the regression average. The full account — the populations behind each equation, what a bounced rep does to it, and why we stop at ten reps — is set out on the methodology page. Warm up thoroughly and use safety bars or a spotter before going anywhere near 384 lb. This is a training estimate, not medical advice.